AutoLocation Geofence not updating state

Discussion in 'AutoApps' started by quintaar, Jun 27, 2015.

  1. quintaar

    quintaar New Member

    Joined:
    Jun 27, 2015
    Messages:
    3
    Likes Received:
    0
    Hello,

    I have created a geofence (radius about 2km). I have issues returning the state. In the app itself - my location is shown as outside the fence radius - however the fence persist on claiming I'm inside. I'm rooted, I run custom but near stock rom with no modifications. The location is set to high accuracy, I have GPS 3G and WIFI on.

    This leads to tasker fireing 2 fences at the same time. Any ideas?
     

    Attached Files:

  2. quintaar

    quintaar New Member

    Joined:
    Jun 27, 2015
    Messages:
    3
    Likes Received:
    0
    ok not sure what I did but I managed to get this updating now. There was another issue though. When Geofence is created, and task enabled - the geofence responds as inside for a brief moment - triggering the tasks. This is happens most often when previous geofence was deleted (with a higher raduis - ie 5km) and new one is created with the same name with a smaller radius (ie 2km) - for a moment this gets activated - which ruins the task created. Is there any setting i should be aware of?
     
: geofence

Share This Page