Search Results

Post

When both conditions are met the task should click a button but it doesn't happen. I can see the screen refresh until it gets the desired...

Post by: Bill2938, May 22, 2017 in forum: AutoApps

Post

The task refreshes a screen in an app until it detects an "offer". The offer has several elements that I can use in takser but so far I am only...

Post by: Bill2938, May 18, 2017 in forum: AutoApps

Post

I use UI Query to set two variables from a particular screen. If I get a match in the IF statement on both then proceed to the task, if there is...

Post by: Bill2938, May 17, 2017 in forum: AutoApps

Thread

Is it possible to use an IF statement multiple variables in an AND statement?

Thread by: Bill2938, May 16, 2017, 7 replies, in forum: AutoApps

Post

Is there a command to stop a task on any touch to the screen?

Post by: Bill2938, Nov 1, 2016 in forum: AutoApps

Post

I have done that as there were changes in the UI for sure. Is it possible for the app designer to block interaction from Autoinput?

Post by: Bill2938, Oct 31, 2016 in forum: AutoApps

Thread

I recently upgraded the target app that I run a task against. While trying to make the necessary adjustments in Tasker I began getting errors and...

Thread by: Bill2938, Oct 30, 2016, 16 replies, in forum: AutoApps

Thread

I have created a loop that refreshes the screen in a pp I use for work. I am looking for a massage to show up after refresh that says Ready to...

Thread by: Bill2938, May 12, 2016, 0 replies, in forum: AutoApps