hey, on my autotools webscreen when I set the %atcommand once tasker reacts as expected but when I set the %atcommand more than once it doesn't work. Example: sliding an image to the left on my webscreen sets the %atcommand and tasker takes me to my phones homescreen which is what I want. But if I set the %atcommand beforehand by doing something else, like by sliding a menu (but still staying on the webscreen) and then slide the image to go to my homescreen it doesn't work. A message pops up saying the %atcommand has changed to what I want but nothing happens. Do I need to reset the %atcommand or something? Also, is there a way to change the webscreen's timeout value after the webscreen has been created? or a way to close it without relying on the timeout? and is there a way to stop the popup messages that show everytime I set %atcommand? Thanks.