AutoVera What is the variable for smart switch and door sensor?

For some reason autovera cannot seems to recognise the variable coming from above devices and I am unable to perform a status update.

Is there anyway I can check what variable is generated via autovera when I activate the devices?

Sent from my SM-G955F using Tapatalk

 

how about do I do that?
please assist.
thanks

Sent from my SM-G955F using Tapatalk

 

ok thanks I have found the device info....but which variables shall I use for a smart switch on and off variables as I dun know what is generated from the device? normally on is 0 and on is 1 right?

I try both on avstatus still not reporting T.T

Sent from my SM-G955F using Tapatalk

 

I managed to get feedback finally by using back %avnewstatus and define the new and old variables to 1 & 0.

But what is strange is the else if don't work. end up I need to create a separate profile for open or close.

How to make them in to a single profile where the else if will work?

Sent from my SM-G955F using Tapatalk

 

please see below....I check again something is wrong.
I tried again on the switch it is still not getting variables T.T





Profile: Dyson Charging Status (88)
Event: AutoVera Status Update [ Configuration:Vera: Gix Veraplus
Device: Store Smart Switch
Service: Power Switch
Variable: Status
Old Value: 0
New Value: 1 ]
Enter: Anon (89)
A1: AutoVera Settings [ Configuration:Vera: Gix Veraplus
Device: Store Smart Switch
Status Updates: Enable Timeout (Seconds):0 ]
A2: AutoVera Devices Info [ Configuration:Vera: Gix Veraplus
Device: Store Smart Switch
Room: KITCHEN Timeout (Seconds):60 ]
A3: If [ %avstatus() ~ 0 ]
A4: Say [ Text:%avname() had completed your dyson vaccum charging process Engine:Voice:default:default Stream:3 Pitch:4 Speed:4 Respect Audio Focus:On Network:Off Continue Task Immediately:Off ]
A5: Else If [ %avstatus() ~ 1 ]
A6: Say [ Text:%avname() had began your dyson vaccum charging process Engine:Voice:default:default Stream:3 Pitch:5 Speed:5 Respect Audio Focus:On Network:Off Continue Task Immediately:Off ]
A7: End If


Sent from my SM-G955F using Tapatalk

 

flash action?

Sent from my SM-G955F using Tapatalk

 

ok understood.
the variables flashed is 0 when I tested the task itself.

But still cannot works. it seem that the variables from the smart switch is not what 0 or 1?

Sent from my SM-G955F using Tapatalk

 

no I meant I try to toggle the switch physically but tasker is not getting the variables 0 or 1 I guess. therefore it does not work

Sent from my SM-G955F using Tapatalk

 

that's puzzle me as well as well. T.T
I am not sure as well what to do next



Sent from my SM-G955F using Tapatalk

 

I toggled the actual smart switch but the tasker does not response to the status at all whether if I on or off the actual smart switch.

Hope this helps

Sent from my SM-G955F using Tapatalk

 

yup

Sent from my SM-G955F using Tapatalk