AutoTools Disable system-wide vibration?

Discussion in 'AutoApps' started by Diggitydogg, Dec 31, 2017.

  1. Diggitydogg

    Diggitydogg New Member

    Joined:
    Dec 31, 2017
    Messages:
    2
    Likes Received:
    0
    Is there any possible way to disable system-wide vibration? I'd like to be able to have my vibration disabled while the screen is awake and re-enabled when the screen turns off. Any ideas on this? I have a Note 8 running 7.1.1 if it matters.

    Thanks!
     
  2. Sergpot

    Sergpot New Member

    Joined:
    Oct 17, 2017
    Messages:
    10
    Likes Received:
    0
    Give this a try
    Profile > Display state > off --------- Action > Do not disturb > None
    Profile > Display state > on --------- Action > Do not disturb > All
     
  3. Diggitydogg

    Diggitydogg New Member

    Joined:
    Dec 31, 2017
    Messages:
    2
    Likes Received:
    0
    This is overkill though. The only thing I want to stop from happening is the vibration alert for notifications no matter what mode the sound toggle is in. The Tasker Vibrate on Notify appears to have been deprecated at some point so I was wondering if AutoTools had a way to mimic that behavior (which I think did what I'm looking for, though I am not sure to be honest). I used to have a jailbroken iPhone and using Automator I could just disable vibration while screen on. Granted, there is a toggle switch in the settings of iOS for that.
     
  4. Sergpot

    Sergpot New Member

    Joined:
    Oct 17, 2017
    Messages:
    10
    Likes Received:
    0
    Only effect is, notifications will arrive silenced. Isn't that what you want?
     
  5. joaomgcd

    joaomgcd Administrator Staff Member

    Joined:
    Feb 3, 2015
    Messages:
    8,488
    Likes Received:
    720
    Did you try using the Secure Settings assistant in the AutoTools beta? :) If there's a secure setting for that it should show up that way.
     
  6. bmello777

    bmello777 Member

    Joined:
    Oct 19, 2016
    Messages:
    35
    Likes Received:
    0
    This would help because my Nokia 6.1 has very weak USB charging connections . If I could turn off the vibration system-wide (but keep the sound), it would allow my phone to charge more without interruption from loose charger port connections.
    I have been using the do not disturb mode, but that is not ideal for the task at hand.

    I haven't found an option in the system settings that allow for this
     
: Vibrate, tasker

Share This Page