Hello everyone! Long story short, I use AutoVoice and Tasker to send voice commands to our KNX home automation. Everything worked great so far, so I decided to integrate a wearable into this setup, because it's so much easier to shake my wrist and then say "open the front door" than it is to take the phone out of my pocket, turn the screen on and then say "Ok, Google - open the front door". Got the watch yesterday, set everything up and played with it half the day. Everything worked great. But this morning something funny happened. There I was in front of my door, shaking my wrist like and idiot and nothing happened. Went to AutoWear Settings thinking of resetting "Shake Setup" only to find that it doesn't register any movement. The MotoBody app would sometimes register steps and sometimes will not. The Titlt to turn screen on worked flawlessly. No matter how much I shook my wrist, the Autowear voice screen did not come on. I finally reset it and it worked fine for a couple of hours. Then, while I was in front of the door again, shook my wrist and nothing. Checked out the watch and it kept connecting and disconnecting from the phone. I've been trying all kinds of stuff to get it fixed, but so far...nothing. I'm wondering if this is a problem with the watch, or maybe a bug in Autowear. I checked the logs, and the &SHAKE& command doesn't appear anymore, so it clearly doesn't register the shake. So until I can fix this, I put an icon that opens the Autowear voice screen. An yet again, in front of the door, must have repeated the command "open front door" about 5 times without Autowear recognizing the words, and after that the watch disconnected. I'm guessing it might be related to the fact that my phone switches networks in front of the door (from 3G to the wireless network), but since the phone and watch are connected by bluetooth it shouldn't disconnect, right? Also, on a sort of semi-related matter: Google Services and Google app are draining my phone battery like crazy! About 12% for Services and 10% for Google App. Any ideas on this? Thanks and sorry for the wall of text Edit: I played with the watch some more and noticed that after it's been idle for a while, when I tap the AutoWear icon, it will not register my voice, will disconnect and then reconnect in a few seconds. Not sure if this is only happening with AutoWear commands or with something else too, I'll have to keep an eye on it. Edit 2: Seems to disconnect even if I'm sending a voice command in a different App (Hangouts of example), not necessarily sending an AutoWear command.