AutoTools USB Debugging

Discussion in 'AutoApps' started by scotts, Nov 6, 2016.

  1. scotts

    scotts Member

    Joined:
    Jun 19, 2015
    Messages:
    140
    Likes Received:
    1
    Any means of enabling/disabling USB Debugging? I can't find such Custom Setting for my device.

    I'm mainly wanting this so I don't get the MTP 'Allow access to device data' dialog pop-up.

    Scott
     
    scotts, Nov 6, 2016
    #1
  2. joaomgcd

    joaomgcd Administrator Staff Member

    Joined:
    Feb 3, 2015
    Messages:
    9,479
    Likes Received:
    806
    joaomgcd, Nov 8, 2016
    #2
  3. scotts

    scotts Member

    Joined:
    Jun 19, 2015
    Messages:
    140
    Likes Received:
    1
    That's cool. However, i could not use it for USB debugging, as I need that to run adb.

    I did try it for power button immediate lock, but no changes to anything related to it were shown. There was a change in aod_show_state, but that's for Samsung Always On Display.

    Sent from my SM-G935V using Tapatalk
     
    scotts, Nov 10, 2016
    #3
  4. Suntzu

    Suntzu New Member

    Joined:
    Nov 9, 2016
    Messages:
    2
    Likes Received:
    0
    Use Global setting adb_enabled. The value is either 0 or 1, to disable and enable it respectively.
     
    Suntzu, Nov 22, 2016
    #4
  5. scotts

    scotts Member

    Joined:
    Jun 19, 2015
    Messages:
    140
    Likes Received:
    1
    Nice. Thank you.

    Sent from mTalk
     
    scotts, Nov 23, 2016
    #5
: USB debugging

Share This Page